Tip:
Highlight text to annotate it
X
The following video displays the loading instructions for the Coreless JRT Tissue Dispenser. Always
wear appropriate protective gear and follow all safety regulations and procedures. See
product insert for additional information and warnings. Install a new roll by aligning
dimple in the centre of the tissue with the left arrow on the lower left corner of the
dispenser front. Push the roll upward until it locks in place. Make sure the tissue unwinds
in a clockwise direction. When a roll is installed properly there is a one inch of tissue exposed.
When the tissue is no longer visible through the window the roll can be transferred to
the stub roll holder. To remove the partial roll push it up until the roll is free of
the holder. The roll can now be removed on either the right or left side of the holder.
Flip the partial roll around so that the paper unrolls in a counter clockwise direction and
install it in the right position. Install a new roll in the left position so that the
paper unrolls in a clockwise direction. Push it up firmly until the roll locks securely
in the roll holder for body tail from the stub roll. In the unlikely event it is necessary
to remove a full roll use your fingers to depress the metal roll holder spring behind
the roll while gently pulling down on the roll with a rocking motion. Do not force the
roll out by pulling straight down or damage will occur to your dispenser.