Tip:
Highlight text to annotate it
X
The following video displays the mounting instructions for the Coreless JRT Tissue Dispenser.
Always wear appropriate protective gear and follow all safety regulations and procedures.
See product insert for additional information and warnings. First determine at what height
the dispenser will be hung. KC recommends at least 30 inches from the floor to the bottom
of the dispenser and 12 inches from the front edge of the toilet to the centre of the dispenser.
The mounting bracket should be installed 7 inches higher than the desired location for
the dispenser bottom end. Use the enclosed mounting bracket as a template. Use the bracket
to determine where the screw holes will be, mark the wall accordingly. Drill the holes
and insert the wall anchors then screw the mounting bracket into the wall allowing the
dispenser over the bracket lining up the anchors on the back with the protrusions on the bracket.
Push firmly to hold in place while the dispenser is hanging on the wall, mark the wall for
the bottom two screw holes, remove the dispenser and drill the wall for the remaining two wall
anchors. Reattach the dispenser and screw in the final two holes. Use a power driver
with a long bid extension for the bottom two screws. Now you are ready to load the tissue
roll.