Tip:
Highlight text to annotate it
X
Double click on the line tool. Set the properties to: Length 40, Angle 90
Click on Grid Lock
Put your line near the centre of the screen.
Click on contour parallel to a line. Set properties to: Contour Spacing 40.
Contour 3 lines
Click on the Line Tool. Double click on the Attach tool. Set it to End point (or node). Attach the first line with the last one.
Select Contour Parallel to a line. Set properties to: Contour Spacing 40mm Contour the newly drawn lines.
Attach (end point) your newly drawn lines to the past drawing.
Contour the newly drawn lines with 40mm Contour Spacing
Click on Delete PArt and delete the lines you dont need. (You should end with a cross)
Select Contour Parallel to a line with the following properties: Contour Spacing 5mm Contour the lines shown in the video
Select the line tool. DOuble click on the Attach tool. De-select end point and select Intersection. Draw a line on the little squares you have contoured
Now double click on the Attach tool. De-select Intersection. SElect end point. Attach the lines which are shown in the video.
Contour your newly drawn lines 5mm.
Click on the Line tool. Double click on the attach tool. De-select end point. Select Intersection Draw lines on your previously drawn squares.
This might seem a complex drawing. But if you click on delete part and delete your construction lines you will notice how simple it is.
Select Contour a parallel line. Set the contour properties to: Contour Spacing 30mm
Select the line tool. Double click the Attach tool. Make sure end point is selected. Attach your line to the net.
Double click to the line tool. Set the properties to: Angle: 45 Draw the line
Delete the lines you don't need.
Draw a circle with the following properties: Radius: 10. Attach it to the end of your new line.
Delete you construction lines.
Repeat the last steps on the four sides.
You should have a develpment like this one.
MORRIS CABRO!!!!!!!!!!