And a lot of tires have treads on them, so you want to make sure that the tread is going
the correct way. Basically if you see, you have gears in the back, basically what would
have to happen is the tread would have to go with the wheel so you could see it would
go this way.
And a lot of the time what we like to do is we like to put the actual label right where
the valve is. So if you do have a flat and you pump up your tube, you can see exactly
where the hole would be. It makes it a lot easier for fixing flats. So you just put the
one side on and then you're gonna get your tube and make sure that you pump up the tube
slightly just so it becomes round so it's easier to put inside the tire and also so
you don't pinch it when you're putting on the other side. And you start with the valve
here, put the valve in, pull the tire over the tube, and start pushing the tube inside
the tire and the rim. So once you get it inside the tire and the rim, what you're gonna do
is you're going to push the other side of the tire, the sidewall of the tire, on the
actual rim.
So you're going to start at the valve, you're going to start opposite where you took if
off and basically use the back of your hand to push the tire on, making sure that you're
not pinching the tube. So you want to make sure that the tube isn't hanging out here
'cause it'll actually pinch, it's like a pinch flat, and then you'll have to replace the
tube. So you kind of just want to go all the way around holding the tire. Sometimes it
gets a little difficult like right at the end here, so you can take a tire lever, make
sure that you're not pinching the tube, use it backwards. So instead of using it this
way like taking off the tire, you turn it upside down and you just hook the tire up
on to the rim. Once the tire is on the rim, you want to make sure that you start inflating
it. Well, before you do that make sure that the tire is seated properly, so basically
what that means is there's a seam that runs around most tires that should be even all
the way around on both sides. If it's not then it can cause a blowout which is never
good. So as you pump up the tire make sure you keep on looking at the seam to make sure
that it's seating properly and make sure that you're keeping an eye on your gauge to see
what pressure it's at. Every tire is a little different. It will actually say on the sidewall
of the tire.
This tire says 'Maximum inflation pressure - 65psi', so I wanna make that I do somewhere
around 65 psi. So once you get up the pressure make sure that you remember to tighten down
that screw if it's a Presta valve. If it's a Schrader valve make sure to put the cap
on it because it prevents dirt from getting into the valve. And that's how to replace
a tire.