Tip:
Highlight text to annotate it
X
So, our bunraku arm control. I've just put a tiny little brad into that handle that grip
so that it no longer rotates around or wants to come off. I recommend also gluing it in
place. Once you're done with your whole project and you're happy with everything. What is
that old adage? Measure twice cut once? That also goes with gluing. Measure twice glue
once. I've also drilled a hole where I'm going to be attaching that toggle. And that's a
one-eighth inch hole because I'm going to be using a cotter pin which needs to rotate
within it that's about the same size. And I've marked with a nice fuschia Sharpee the
line along which each of my two brass tubes are going to lie. You can see where I was
holding the tube. And now I'm going to glue them on with hot glue and this is another
product placement. I recommend the high strength hot glue from Winks Hardware. You can find
it on the Internet.