Tip:
Highlight text to annotate it
X
Sublimating an image onto coasters
Create you design using the supplier template and print
Cut any print into the individual pieces
This make them more manageable to take the transfer to the coaster
Remove the protective film from the coaster
It is sometimes easier to do this by holding the coaster to the heat press for a couple of seconds before peeling off
The design should be slightly larger than the coaster
When you place the coaster face down on the transfer you can see a small amount of the image showing around the edge
Using the heat resistant tape hold the coaster into position on the transfer
Place the coaster on the heat press with the transfer paper on top
Cover with a Teflon sheet
Using medium pressure press for 60 seconds at 200 degrees C
When the time is finished open the press and quickly remove the transfer
Your coasters are complete
For more How To Sublimate video tutorials visit www.sawgrasseurope.com