Tip:
Highlight text to annotate it
X
Coming back to your bunraku arm control, the next step in the process is to prepare the
two tubed channels through which your Dacron string is going to run. That's the string
that you're going to be manipulating in order to move that hand back and forth on the wrist
joint. So you're going to take your one-eighth inch brass tube. You're going to be laying
it along the top of your arm rod in the same line as that center line along which you attached
your hinge hasp, parallel to that hinge hasp line. And that's going to extend from just
behind the hinge. I do it about an inch behind the hinge on the wood, past your elbow hole.
Let's say two inches approximately. That's a nice spot. So, we're going to go cut that
on the band saw right now.