Tip:
Highlight text to annotate it
X
Today on this 2008 Chevrolet Cobalt we are going to install part number V58020 from Valley.
The hitch is going to mount up on the frame and the bumper structure itself. On the frame
there is actually a hole that is marked out from the overlapping pieces of steel, we will
go ahead and use that as a mounting point. And the other two holes that go into the bumper
structure, we will use the hitch as a template. :21
It will be identical on the drivers side except, we will have to lower the muffler to give
us a little more working room. We will go ahead and spray down the rubber hangers with
some lubricant. Pull down on it a little bit and spray it into it, and it will easily slide
off. All right we will go ahead and start off with our 1/ 4 inch pilot hole and work
our way up to a 1/ 2. You can go a little over a 1/ 2 inch to give you more working
room for the bolt and wire pull. Once you have one side drilled out
we
will
go ahead
and repeat on
the other side. :54