Tip:
Highlight text to annotate it
X
Today on our 2005 Chevrolet Equinox, we'll be test fitting the Pro Rack two by carrier,
part number PR8062403. To begin our test fit, we'll slide the shank of the carrier into
the receiver tube of the hitch, line up the pin hole, and thread in our anti-rattle bolt,
tightening it with a wrench, and installing the clip on the other side. Now we'll
go over some key measurements. We have nine and a half inches of ground clearance. The
closest point of the carrier to the rear of our Equinox is about an inch. We've added
twenty four inches to the overall length of our vehicle. We'll pull the pin at the
base of the carrier to allow our carrier to tilt away from our vehicle. This allows us
to gain access to the cargo area of the Equinox by opening our rear hatch. With our mass back
in its upright position and our pin reinstalled, we can undo the cradle straps
to expose our cradles.